Pioneer PRO-R06U Training Manual page 31

2.2. FUNC.CHECK Function Check mode
Operation item
No.
1 FAN
2 AFT
1. FAN
Forces the setting of FAN speed (MAX: High speed/MIN: Low speed/STOP: Stops FAN).
NORMAL is for normal operation (i.e. the rotational speed changes according to temperature change).
During Sevice Factory mode, the temperature sensor will operate accordingly to the displayed data.
After exiting the Service Factory mode, the compulsive setting is cancelled, and the FAN wil return to
normal operation mode.
If rotational speed was compulsorily changed via 232c command, make sure to return the speed to
normal operation mode when finished.
2. AFT
Exclusively used for production line.
AFT action is stopped, and assign whether to track down or not during channel tuning.
Display
Forces the setting of FAN speed.
Controls AFT action by turning ON/OFF.
Figure. FAN
Command
FCN+S00 NORMAL
FCN+S01 MAX
FCN+S02 MIN
FCN+S03 STOP
31
Content
Detail
RS232C
FCN
AFT