Mounting The Printer On A Vertical Surface; Spill Shield Option Installation - CognitiveTPG A799 User Manual

14 Chapter 3: Setting up the Printer
Mounting the printer on a vertical surface (using optional kit TPG-K260)
1 Select a location that allows adequate support for the printer and is within easy cable length of the host.
2 Follow the instructions provided with wall-mount kit
(K260) to attach the bracket to the vertical surface and
the printer to the bracket.
Caution: Attach the power and communication cables to
the printer prior to attaching the printer to the
bracket.

Spill shield option installation

Top and bottom spill shields provide added protection for your printer from moisture or spills. The following instructions
describe how to install both of these shields. Shields may be installed individually or as a set.
Tools:
Phillips head screwdriver
1
To install the top spill shield:
1 Clean the printer receipt cover in the area where the top spill cover is to be installed.
2 Remove receipt cover and drill holes using a #5/32 or 4 mm drill bit (as shown). Open holes further by drilling with a
5/16 or 8 mm drill bit.
3 Position the spill shield to the printer.
4 Fasten spill shield to receipt cover with screws and washers provided.
A799 Two-Color Thermal Receipt Printer: User Guide
Drill 5/16" hole
2
������� ���������
Bracket
Power
Supply
Ty-Wrap
Cord
Ty-Wrap
Screws &
Anchors
�������� �������
Bracket
A799-UG00001 Rev. C
Power
Supply
�������
Cord
12/08