1
CHARGE & LOAD BATTERY
A
4
BUTTONS & LIGHT
Press Power (A) to turn the printer on. Press Feed (B)
to feed a label. The light (C) indicates:
•
Steady green: Label feeding or
printing, ready to print.
•
Slow blinking green: Power save
mode, ready to print.
B
•
Fast blinking green: Receiving data.
•
Green/red alternating: Printing a
test label, hex dump mode.
•
Red Blinking: Low battery.
•
No LED: Power off.
See Programmer's Guide to adjust
the power-save modes.
2
CABLE OPTION
A.) Insert the cable (ordered separately)
into the strain relief clip.
B.) Connect the RJ45 cable to the printer.
C.) Attach the strain relief clip to the
top of the printer with the screw.
5
BELT CLIP & ACCESSORIES
A
Attach the belt clip by holding it
C
perpendicular, at a 90° angle, to
the printer. To remove the clip
depress the latch (A) and reverse
this operation. In normal use, the
printer will not unclip accidentally.
Contact Cognitive for other
accessories, including:
•
Shoulder strap
•
All-weather carrying case
3
A
TO OPEN: Push UP the yellow tabs
(A) and pull the door out (B).
Lay the loose end of the media over
the center of the rubber roller.
IMPORTANT! Do not use too much
force when attaching the strain relief
IMPORTANT! The label imaging surface must be centered and face up. Latch
screw or risk damaging the printer
both sides of the door to ensure proper print quality.
and/or clip.
6
Remove several labels from the label backing. Open the peeler (A) and feed the
label over the peelbar and under the peeler mechanism (B). Center the label
backing and close the peeler.
A
A
LOAD MEDIA
B
TO LOAD: Secure the media roll
between the guides.
TO CLOSE: Press the front cover until
you hear the cover click. Press the
FEED button to position the label.
PEELER OPTION
B