BriskHeat Metal Clad Hopper Heater Instruction Manual

Metal clad hopper heater

Download this manual

Enlarged version

WARRANTY INFORMATION

BriskHeat

warrants to the original purchaser for the period of 5 years

from date of shipment. Contact factory at 1-800-848-7673 (toll free,

U.S. / Canada) or 614-294-3376 for complete details.

1055 Gibbard Ave, Columbus, OH 43201

Toll Free: 800-848-7673

Phone: 614-294-3376

Fax: 614-294-3807

Email: bhtsales1@briskheat.com

BriskHeat

Metal Clad Hopper Heater

PN: 41301 Rev. A

Metal Clad Hopper Heater

Instruction Manual

Read and understand this manual before operating or

servicing this heater. Failure to understand how to

safely operate these heaters could result in an

accident causing serious injury or death. Only

qualified personnel should operate or service heater.

Need help?

Do you have a question about the Metal Clad Hopper Heater and is the answer not in the manual?

Page 1 Metal Clad Hopper Heater WARRANTY INFORMATION ® BriskHeat warrants to the original purchaser for the period of 5 years from date of shipment. Contact factory at 1-800-848-7673 (toll free, U.S. / Canada) or 614-294-3376 for complete details. Metal Clad Hopper Heater...
Page 2 Table of Contents TROUBLESHOOTING GUIDE Introduction ..................2 ® Please read this guide prior to contacting BriskHeat . This guide is designed to Safety Alert Symbol ................ 2 answer the most commonly asked questions. If you are unable to identify the Important Safety Instructions ............
Page 3: Important Safety Instructions
Do not wrap the heater over itself.  ® that is mated to a receptacle connected to the power source. BriskHeat Metal Only qualified personnel are allowed to ...
Page 4: Prior To Installation
Metal Clad Hopper Heater Metal Clad Hopper Heater MOUNTING 1.) Mark Locations of Mounting Holes to surface. Use “System Drawing” to see how Read and understand this entire manual before operating this electric heater. to place metal clad heaters on the hopper. The “System Drawing” should be used PRIOR TO INSTALLATION when wiring and placing heaters on unit.