Summary of Contents for BriskHeat XtremeFLEX HSTAT-R Series
Page 1
Emergency De-Icer (HSTAT-R Series) Instruction Manual Read and understand this material before operating or servicing this heater. Failure to understand how to safely operate these heaters could result in an accident causing serious injury or death. These heaters should only be operated by qualified personnel.
For additional information concerning this, ® or other BriskHeat products, please ® contact BriskHeat at 1-800-848-7673 (toll Immediate hazards which WILL result in severe free, U.S.
It is highly recommended that a ground fault circuit breaker is used. Failure to observe these warnings may result in personal injury or damage to the de-icer. ® BriskHeat Corporation. All rights reserved...
Do not overlap de-icer tape on itself (B). Thermostat sensor must be in full contact with object to be heated. Sensor is located underneath temperature controller box (C). STEP 3 Plug power cord into appropriate electrical power outlet. ® BriskHeat Corporation. All rights reserved...
1/2” thick fiberglass insulation or equivalent insulation rated to the appropriate temperature. Temperature controller dial and enclosure will become very hot after use. Always unplug heater and allow to cool prior to handling. ® BriskHeat Corporation. All rights reserved...
If you are unable to identify the problem or need ® additional assistance, please contact your local BriskHeat distributor or contact us toll free (U.S. / Canada only) at 1-800-848-7673 or 614-294-3376 or bhtsales1@briskheat.com. PROBLEM SOLUTION(S) Does not heat Verify de-icer is connected to proper voltage.
BriskHeat ’s obligation and the exclusive remedy under this warranty shall be limited to the repair or replacement, at BriskHeat®’s option, of any parts of the product which may prove defective under prescribed use and service following ®...
Need help?
Do you have a question about the XtremeFLEX HSTAT-R Series and is the answer not in the manual?
Questions and answers