Cordless Handset - Motorola STARTEC SC200 User Manual

1. Plug the telephone line cord into the socket marked
on the underside of the base.
2. Plug the power adaptor into the socket marked
the underside of the base and plug the other end into
the mains power wall socket. Switch on the
mains power.
3. Plug the curly cord into the corded handset and the
telephone base.
Connecting the charger and charging the

cordless handset

1. Plug the power adaptor into the socket marked
the underside of the charger and plug the other end into
the mains power wall socket.
2. Remove the battery cover from the back of the handset
and insert the 2 x AAA NiMH rechargeable batteries
supplied. Please note the '+' and '-' markings inside the
battery compartment and insert in the correct direction.
8
3. Clip the battery cover back into place.
4. If you are charging the batteries for the first time, place
the handset on the charger to charge for at least 24
on
hours continuously.
While charging,
stop flashing.
5. The display will show the handset name and number to
indicate that it is registered to the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH
battery cells (2 x AAA Ni-MH 450mA rechargeable
batteries) supplied with your SC200.
on
Please do not use alkaline or non rechargeable batteries. It
may cause permanent damage to the product and void the
warranty.
BATTERY LOW WARNING
If you hear a warning beep every 30 seconds during a call,
you will need to recharge the handset before you can use
it again.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up
to 7 hours talk time or up to 130 hours standby time on a
single charge.
1
Note that new batteries do not reach their full capacity until
they have been put to normal use for several days.
will flash, once fully charged it will
Getting started