icon flashes
• Handset is out of range. Move closer to the base.
• Make sure that the handset is registered to the base,
see page 31.
• Check that the mains power is connected properly and
switched on.
Keypad does not seem to work
• Check that the keypad lock is not on, see pages 18 and 24.
icon is not flashing during charge
• Adjust the handset slightly on the base.
• Clean the charging contacts with a cloth moistened with
alcohol.
• Check that the mains power is connected properly and
switched on.
• The battery is full. When the handset is fully charged,
will appear steady on the display.
No Caller ID
• Check your subscription with your network operator, see
pages 19 and 34.
• The caller may have withheld their number.
• The record cannot be found in your phonebook. Check
that you have the correct name / number stored in your
phonebook, with the full area code.
Help
I have forgotten my PIN!
• Restore your SC200 to its default settings, see, page 32.
Cannot register a handset to the base
You can register up to a maximum of 4 handsets to a
SC200 base. You must de-register a handset in order to
register a new one, see page 31.
• Check that you have entered the correct PIN code
(default = 0000).
• Check that you are at least one metre away from other
electrical equipment to avoid interference
when registering.
Handset does not ring
• The handset ringer volume may be set to Off, see page 27.
Base unit does not ring
• The base ringer volume may be set to Off, see page 18.
Noise interference on my phone or on other
electrical equipment nearby
• Place your SC200 at least one metre away from
electrical appliances or any metal obstructions to avoid
any risk of interference.
37