Using Black Soap Nozzle; Apply Detergent - Hyundai HYW2500P Operator's Manual

er Equipment
To apply detergent, follow these steps:
1. Fit black soap nozzle.
2. Prepare detergent solution as required by job.
3. Place small filter end of detergent siphoning tube into detergent
container.
NOTE: Make sure the filter is fully submerged in detergent while applying
detergent.
THIS WASHER WILL ONLY DRAW SOAP WITH THE BLACK
SOAPER NOZZLE. WHITE, RED, AND YELLOW NOZZLE WILL NOT
DRAW SOAP.
4. Make sure black nozzle is installed.
5. Make sure garden hose is connected to water inlet. Check that high
pressure hose is connected to spray gun and pump. Turn on water.
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without the
water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this instruction
will void the warranty.
6. Start engine following instructions Starting Your Washer.
7. Apply detergent to surface, using long, even, overlapping strokes.
8. Allow detergent to "soak in" for 5 minutes before washing and
rinsing. Reapply as needed to prevent surface from drying. DO NOT
allow detergent to dry on.
IMPORTANT: You must flush the detergent siphoning system after each
use by placing the filter into a bucket of clean water, then run the
pressure washer in low pressure for 1-2 minutes.
Chemicals can cause bodily injury and/or property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergent/soaps. Follow all
manufacturers instructions
www.hyundaipowerequipment.co.uk

using black soap nozzle

NOTICE
CAUTION
23