Manual Tuning - Fm - Roberts DAB/FM/CD Stereo Clock Radio User Manual

Manual tuning - FM

1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press the On / Off button to switch on your clock radio.
3. Press and release the Function button until the FM band is selected.
4. Repeatedly press and release the Tuning Up or Down buttons to
tune to a station. The frequency will change in steps of 50kHz.
If the radio is tuned to a station of suffi cient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Adjust the Volume control to the required setting.
7. To switch off your clock radio, press the On / Off button.
Note: If you fi nd that FM reception is poor, try repositioning the wire aerial.
Fully extend the wire aerial located on the rear of your clock radio. Place
the wire antenna so that it is as straight as possible extending either above
or below the radio. If you fi nd that an FM broadcast has a lot of background
hiss, this may often be reduced by setting the radio into Mono reception
mode for the current FM station. Please refer to the section "Stereo / Mono
setting - FM" on page 15 for further details.
13
2,7
3
4
4
6