Handling Liquid Damage; Automatic Eco (Power Save) Mode - Uniden XDECT 8055 Owner's Manual

Xdect 8055 series
Table of Contents

Advertisement

Handling Liquid Damage

Moisture and liquid can damage your cordless phone.
If the handset or base is exposed to moisture or liquid, but only the

exterior plastic housing is affected, wipe off the liquid, and use as
normal.
If moisture or liquid has entered the plastic housing (i.e. liquid can

be heard in the phone or liquid has entered the handset battery
compartment or vent openings on the base), follow these steps:
Handset
1.
Remove the battery cover & disconnect the
battery.
2.
Let dry for at least 3 days with the battery
disconnected and the cover off for ventilation.
3.
After the handset dries, reconnect the battery
pack and replace the cover. Recharge the
battery fully (15-20 hours) before using.
IMpOrTANT: you must unplug the telephone line while
recharging the battery pack to avoid charge interruption.
CAUTION! DO NOT use a microwave oven to speed up the
drying process. This will cause permanent damage to the
handset, base and the microwave oven.

Automatic ECO (Power Save) Mode

Handset
ECO mode activates automatically during Talk or Intercom modes,
if the received signal is good, to reduce power consumption. ECO
shows on the display when ECO mode is active. If the received signal
becomes poor, ECO mode will be released and ECO will be turned
off.
Base
If the base has only one handset registered (i.e. no accessory
handsets) then the base will reduce its transmission power when the
handset is on the base.
48
Base
1.
Disconnect the AC
adapter to cut off the
power.
2.
Disconnect the
telephone cord.
3.
Let dry for at least 3 days
before reconnecting.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xdect 8055+1Xdect 8055+2Xdect 8055+3

Table of Contents