Table of Contents
Advertisement
Registering a handset
1)
On the base, open the menu and select Register Handset. The
display should say Handset Registering.
2)
On the handset you want to register, press and hold
handset display says Handset Registering (about 2 seconds).
3)
In about 30 seconds, the handset display should say Registration
Complete. Press
If...
-
you don't hear a dial tone
-
the display says Registration Failed
To register a handset to a different base, see the section
"Expanding Your phone" in the user's guide for the other base.
handling Liquid Damage
Moisture and liquid can damage your cordless phone.
If the handset or base is exposed to moisture or liquid, but only the
exterior plastic housing is affected, wipe off the liquid, and use as
normal.
If moisture or liquid has entered the plastic housing (i.e. liquid can
be heard in the phone or liquid has entered the handset battery
compartment or vent openings on the base), follow these steps:
handset
1.
Remove the battery cover & disconnect the
battery.
2.
Let dry for at least 3 days with the battery
disconnected and the cover off for ventilation.
3.
After the handset dries, reconnect the battery
pack and replace the cover. Recharge the
battery fully (15-20 hours) before using.
IMporTaNT: You must unplug the telephone line while
recharging the battery pack to avoid charge interruption.
CAUTION! DO NOT use a microwave oven to speed up the
drying process. This will cause permanent damage to the
handset, base and the microwave oven.
and make sure you get a dial tone.
TaLk/fLasH
Try...
Making sure the handset is fully
charged, then start over at step 1.
Base
1.
Disconnect the AC
adapter to cut off the
power.
2.
Disconnect the
telephone cord.
3.
Let dry for at least 3 days
before reconnecting.
until the
#
Hide quick links:
Advertisement
Table of Contents
