Connecting The Power Adapter; Verifying The Installation - HP A-MSR900 Series Installation Manual

Connecting the power adapter

The router's power adapter converts AC power to DC power, as follows:
AC rated voltage range: 100 VAC to 240 VAC, 50 Hz to 60 Hz
•
DC Rated voltage: 12 VDC
•
To connect the power adapter, as shown in
Make sure the router is properly grounded. For more information, see
1.
Using the adapter's AC power cord, connect the power adapter to an AC power source.
2.
Connect the DC power cord connector on the power adapter to the DC power receptacle on the
3.
router's rear panel.
Figure 28 Connect the power adapter
1
(1) AC power cord
(3) DC power receptacle

Verifying the installation

CAUTION:
It post-installation check is important to ensure proper operation of the router.
Before powering on the router, ensure that:
There is enough space around the router for heat dissipation.
•
The router is mounted securely on the wall or on a sturdy workbench.
•
Antennae, USB devices, and interface modules are installed correctly.
•
The router and power module are grounded properly.
•
The power supply meets requirements.
•
The router is connected correctly to the console terminal and other devices; parameters are
•
configured correctly on the console terminal.
Before starting up the router, set up the console terminal as described in
and setting terminal
router.
Figure
2
3
parameters." Then, power on the router and perform initial configuration for the
28:
(2) Power adapter
21
Grounding the router.
"Connecting the console cable