Operating Neurotrac™Ifc Rehab; Getting Started - Verity Medical NeuroTrac IFC Rehab Operation Manual

5. Operating NeuroTrac™ IFC Rehab

5.1 Getting started

1. Insert four AA batteries into the battery compartment (the battery images
engraved in the base of the compartment indicates correct battery position.
2. Connect the lead cables to the electrodes. The lead pins must be fully inserted
into the electrode connector.
3. Place the electrodes on the sides prescribed by your physician or therapist,
and press them firmly onto the skin (place the two electrode pairs that are
controlled by the same amplitude buttons on muscles that are about the
same size).
4. Insert the plugs at the end of the electrode lead cable into device output
sockets : CH1 and CH2 output sockets for IFC stimulation or CHA and CHB
output sockets for TENS/NMS stimulation.
5. Press On/Off button to switch the unit on. The unit always starts up with
previously selected programme.
6. Press IFC PROG button or TENS/NMS programme button to select the programme :
a) IFC PROG button: P01 � P11 for preset programmes, PC1 or C2 for
Custom programmes .
b) TENS/NMS PROG button: P01�P12 for preset TENS programmes,
P13�P27 for preset NMS programmes, PC1 for TENS custom programme,
PC1 or PC2 for NMS custom programmes.
NeuroTrac™ IFC Rehab Operation Manual
10