Dhcp Server Settings - D-Link DIR-615 User Manual

Section 3 - Configuration
DHCP stands for Dynamc Host Control Protocol. The DIR-615 has a bult-n DHCP server. The DHCP Server wll automatcally assgn an IP address
to the computers on the LAN/prvate network. Be sure to set your computers to be DHCP clents by settng ther TCP/IP settngs to "Obtan an IP
Address Automatcally. " When you turn your computers on, they wll automatcally load the proper TCP/IP settngs provded by the DIR-615. The
DHCP Server wll automatcally allocate an unused IP address from the IP address pool to the requestng computer. You must specfy the startng
and endng address of the IP address pool.
Enable DHCP
Check ths box to enable the DHCP server on your router. Uncheck to dsable
Server:
ths functon.
DHCP IP Address
Enter the startng and endng IP addresses for the DHCP server's IP
Range:
assgnment.
Note: If you statically (manually) assign IP addresses to your computers or
devices, make sure the IP addresses are outside of this range or you may have an
IP conflict.
Lease Time:
The length of tme for the IP address lease. Enter the Lease tme n mnutes.
Always Broadcast:
Enable ths functon to ensure compatblty wth some DHCP clents.
Learn NetBIOS
If NetBIOS advertsement s swtched on, swtchng ths settng on causes WINS
WAN:
nformaton to be learned from the WAN sde, f avalable. Turn ths settng off
to configure manually.
NetBIOS scope:
Ths s an advance settng and s normally left blank. Ths allows the configuraton
of NetBIOS doman name under whch network hosts operate. Ths settng has
no effect f the " Learn NetBIOS nformaton form WAN s actvated.
D-Lnk DIR-615 User Manual

DHCP Server Settings

28