Setting The Clock - JBL Soundgear SG2020 Owner's Manual

Connections
(cont.)
Headphones
Connecting a headphone 32 automatically dis-
ables the loudspeakers in order to provide a pri-
vate listening session.
Antenna
Important
FM Antenna Connection
Unless radio signals are very weak, no external
antenna is necessary. Simply connect the sup-
plied FM indoor antenna wire to the terminal
marked FM on the back of the unit
AM Antenna Connection
Connect the supplied AM loop antenna to the
terminal marked AM on the back of the unit
FM external
antenna
(not supplied)
75 ohms coaxial cable
FM indoor
antenna
AM
Position
it for the
GND
FM
best
reception
10
GETTING STARTED
Setting the clock will be demonstrated with the
example of 9:25 AM.
Although JBL Soundgear will retain the clock
setting when you power it down into the
Standby mode, the setting will be lost if the
unit is unplugged or the electrical power is
interrupted for more than 10 seconds. In that
event, the clock setting will be erased, and JBL
Soundgear will display a blinking "— : —".
When setting the time, remember that midnight
44 .
is at 12:00 AM and noon is at 12:00 PM.
1. Press the Clock button ™. (If the clock was
previously set, press and hold the Clock button
44
.
for more than 1.5 seconds.)
"12:00 AM" will blink in the Display c, to
indicate civilian 12-hour time. Press the Preset
AM loop antenna
Up c or Preset Down g button to display a
(included)
blinking "0:00", which denotes 24-hour military
time.
2. Choose between the 24-hour display or 12-
hour display by pressing the Preset Up c or
the Preset Down g buttons.
3. Press the Set/Station button ∞ to store this
setting and proceed to the next step.
4. Set the hour by pressing the Preset Up c
or the Preset Down g buttons.

Setting the Clock

5. Press the Set/Station button ∞.
6. Set the minute by pressing the Preset Up
c or the Preset Down g buttons.
7. Press the Set/Station button ∞, and the
clock will resume normal operation.