Casio EX-S1 Service Manual And Parts List page 15

6. Removing the SUB PCB ASSY
1 Unsolder the five lead wires.
2 Remove the hook and then the SUB PCB ASSY.
The SUB PCB is connected to the MAIN PCB by the CONNECTOR.
Note in assembling
*1 Position these four lead wires in the space between the MAIN PCB and the SUB PCB.
*2 Make sure that this lead wire does not touch the battery spring.
1
× 1 *2
2
7. Removing the STROBE UNIT (NOTE: The STROBE UNIT does not need be discharged.)
1 Remove the STROBE PLATE.
2 Remove the CONNECTOR and then the STROBE UNIT.
1
2
× 2 *1
× 2 *1
— 13 —
Remove the CONNECTOR by twisting
it toward the right by a pliers.
NOTE:
Pinch the reinforced part so that the
CONNECTOR is not hurt.
Use a pliers when assembling also.