How To Use - Electrolux DFW51 Instruction Manual

ATTENTION
- Before initiating the usage, wash the reser-
voir with water and neutral soap, in order to
eliminate eventual residues. Refer to the topic
"Water Container Cleaning".
- Use only water proper to consume (drinking
water). The use of any other type of drink can
leave residues, taste or odor in the reservoir.
- The water reservoir shall be filled up only
when it is fit in its position on the door.
- Wait for the water to cool for approximately
12 hours.
- It is possible to hear some noise caused by
the entry of air when the water comes out of
the reservoir.
- If the water does not flow well, push the acti-
vating button again. Stay with the glass under
the water exit for some moments to assure that
all the water is collected by the glass.
- Do not use gasified drinks, such as soft
drinks. The drink can leak off due to the gas
pressure.
Back Spacer
Avoid the fridge to touch the wall.
Keep the back spacers always in
position 1 (horizontal).
When transporting the fridge, keep
the spacer in position 2 (vertical).
This will facilitate the fridge passa-
ge through the door, for instance. Use an adhesive tape
to keep in position 2.
10

4. How to Use

How to turn your refrigerator on and off
To turn your refrigerator on or off, Just connect
or disconnect the plug of the socket, verifying the
correct voltage of the product.
Before turning the refrigerator on for the first time,
read attentively the instructions brochure on the
door and this entire guide.
IMPORTANT
When you turn the Refrigerator off, wait for
10 minutes before turning it on again.
Loading / Replenishing
In the first filling or after cleaning.
1. To best store the recipients in the freezer and
refrigerator compartments, all the shelves can
be removed or replaced and the covers of the
freezer compartments and of the fresh food can
be removed.
2. Connect the plug of your refrigerator in the socket.
3. Let it functioning at least for two hours before
storing any food inside it.
4. Start supplying the food by the shelves of the refri-
gerator, and finally the door shelves. It is important
to respect the maximum limits of charge indicated
in the figure below.
5. After the filling, adjust the temperature control to the
most adequate position, following the information in
the items "Freezer Eletronic Temperature Control"
and "Refrigerator Temperature Control".
6. Do not support food in the air exits, so you don't
endanger the performance of the refrigerator.
Maximum Load Limits