Connect Inlet Hoses - Kenmore 110.2810 Series Installation Instructions Manual

3�
Place drain hose in standpipe
4.5"
(114 mm)
Place hose into standpipe (shown in picture) or over side of
laundry tub.
IMPORTANT: To keep drain water from going back into the
washer:
Do not force excess drain hose into standpipe. Hose should be
secure but loose enough to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
8

CONNECT INLET HOSES

1�
Insert new flat washers
A
A. Coupling
B. Washer
IMPORTANT: To avoid leaks, check that your water inlet hoses
have flat washers at both ends. Washer must be connected
to water faucets with new inlet hoses with flat washers (not
provided). Do not use old hoses. Do not use hoses without
washers.
2�
Connect inlet hoses to water faucets
Make sure the washer basket is empty. Attach the hose labeled
hot to hot water faucet. Screw on coupling by hand until it is
seated on washer. Use pliers to tighten couplings an additional
two-thirds turn. Repeat this step with the hose labeled cold for
the cold water faucet. Both hoses must be connected for washer
to work properly.
IMPORTANT: Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
HELPFUL TIP: Make note of which hose is connected to hot
water to help in attaching hoses to washer correctly.
B