Unpacking And Checking Contents; Assembly; Tools Needed For Assembly And Alignment; Removing And Installing Blades - Bosch CM12 Operating/Safety Instructions Manual

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 10
Before moving the saw: lock
WARNING
the miter lock knob in 45° posi-
tion. lock head assembly in the down position.
Never carry the tool by the cord or head assembly
power switch handle.
The CM12 Miter Saw is shipped complete in one box.
1. Separate all parts from packing materials and
check each one with the "Table of Loose Parts" to
make sure all items are accounted for before
discarding any packing material.
Should be no Gap or Overlap
when Square is Flipped Over
in Dotted Position
To avoid possible injury discon-
WARNING
nect plug form power source
before performing any assembly, adjustment or
repairs.

Unpacking And Checking Contents

Tools Needed for Assembly And Alignment

Combination Square
Combination Square Must be True
Draw Light
Line on Board
Along this Edge

Removing and Installing Blades

2. Table of Loose Parts:
Workpiece Clamp - Used to clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
Multi purpose "L" wrench - Should be stored on
the left rear base.
Miter Lock Knob - Used to lock the table at desired
miter angle.
WARNING
switch on until the missing parts are obtained
and are installed correctly.

Assembly

Multi Purpose "L" Wrench 6/4mm
Straight Edge of Board 3/4"
Thick This Edge Must be
Perfectly Straight
Assembly
Moving Guard Assembly
1. Position the saw in the UP position and at 0°
bevel. If in the DOWN position, press down slightly
on the saw head assembly and pull out the head as-
sembly lock pin (item 36, page 8); then allow the saw
head to come up (See Figure 3).
-10-
If any parts are missing, do not
plug in power cord or turn the