Maintenance; Motor Brushes - DeWalt DW898 Instruction Manual

screw and rotate shoe either clockwise (punch deeper into die) or
counterclockwise (punch out of die). Tighten set screw firmly. Turn
cam shaft with screwdriver in slot to check punch engagement
(moving punch fully down). Repeat as necessary.
DIE REPLACEMENT
If the die becomes dull, replace it. Replace old die by pushing the
cover ring up and out of the die groove. Knock out the retaining pin
under the cover ring with a drift punch. Pull die off the carrier shaft.
Install new die on carrier shaft. Align cross hole in die with groove in
carrier shaft. Install pin. Snap cover ring over die in groove provided.

Maintenance

DISCONNECT TOOL FROM POWER SUPPLY BEFORE PER-
FORMING ANY MAINTENANCE. Check that the punch and die are
sharp. If either is dull, sharpen or replace. Keep the tool clean. Blow
off periodically. Never use solvents or harsh chemicals for cleaning
non-metallic parts of the tool. Use a clean, dry rag only. Periodically
dip the shoe in oil. This is a precision tool. Use it carefully and store
it in a protected place.
Cleaning & Lubrication
Use only mild soap and damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the tool into a
liquid.
Self-lubricating bearings are used in the tool and periodic
relubrication is not required. In the unlikely event that service is ever
needed, service center addresses are packed with your tool.

Motor Brushes

Brush replacement should be performed by authorized service
centers or other qualified service organizations.
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, contact:
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous.
Full Warranty
D WALT heavy duty industrial tools are warranted for one year from
E
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information,
call 1-800-4-D WALT. This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may
have other rights which vary in certain states or provinces.
In addition to the warranty, D
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
D WALT heavy duty industrial tool, simply return it to the participating
E
seller within 30 days for a full refund. Please return the complete unit,
transportation prepaid. Proof of purchase may be required.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-DEWALT for a free
replacement.
4
WALT tools are covered by our:
E