Maintenance; Protecting The Environment - DeWalt DCF500N Original Instructions Manual


CAUTION: Ensure fastener and/or system will withstand
the level of torque generated by the tool. Excessive torque
may cause breakage and possible personal injury.
Cat #
DCF500
1. Install the appropriate anvil
Change Hex) on the tool.
a. If an anvil is installed on the tool, push the release
button 9 on the backside of the tool and remove
the anvil.
b. To install an anvil, push the desired anvil into the tool
until it is secure.
2. Place the accessory on the fastener head.
3. Consider the intended operation and select either forward
or reverse rotation.
4. Press variable speed trigger switch
5. Release variable speed trigger switch
6. If the ratchet stalls, the tool is overloaded or is being
improperly used. Release the variable speed trigger
switch 1 immediately. Do not press the variable speed
trigger switch on and off in an attempt to start a stalled
1
ratchet. Doing so can damage the tool.
7. The ratchet can also be used manually for breaking free
stubborn fasteners or snugging by releasing the trigger and
applying the torque by hand.
nOTE: Excessive manual torque may damage the
included anvils.

MAINTENANCE

Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can cause injury.
The charger and battery pack are not serviceable.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Electrical shock and mechanical hazard.
Disconnect the electrical appliance from the power source
before cleaning.

WARNING: To ensure safe and efficient operation,
always keep the electrical appliance and the ventilation
slots clean.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non‑metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
RPM Ft.-lbs.
0–450 50 (Max.) 67.79 (Max.)
(3/8", 1/4" or 1/4" Quick
2
to start operation.
1
to stop operation.
1
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Ventilation slots can be cleaned using a dry, soft non‑metallic
brush and/or a suitable vacuum cleaner. Do not use water or
nm
any cleaning solutions. Wear approved eye protection and an
approved dust mask.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
w
household waste.
Products and batteries contain materials that can be
recovered or recycled, reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.
Rechargeable Battery Pack
This long‑life battery pack must be recharged when it fails to
produce sufficient power on jobs that were easily done before. At the
end of its technical life, discard it with due care for our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
English
WALT‑recommended
e
11