Ir Code Learning - Remotec ZXT-120 User Manual

IR Code Learning
In case none of the code on the code list works for the targeted air
conditioner, user can use IR code learning function using configuration
according to below steps:
Step
Go to configuration setting page on
the gateway or ZRC‐100 and input
parameter number "27" and
1
parameter value "000" to select the
dedicated AC code number "000"
for learning.
Look up below mapping table (value
0‐22) for learning, and decide the IR
setting you intent to learn next.
For example "22°C, cool" which
matches value "5" (IR code to be
2
learnt will locate at "5" in ZXT‐120).
Set your original air conditioner
remote at "22°C, cool" and turn it
off. (Besides temperature and
mode, you may set other desired
settings, such as Fan, Swing etc.)
Go to configuration setting page on
the gateway or ZRC‐100 and input
3
parameter number "25" and
parameter value "5" (in this case).
Press the PROG button on the ZXT‐
120. (this step apply when using
ZRC‐100 or other portable controller
for set up, if using gateway, user can
4
skip this step)
Aim the original air conditioner
remote at ZXT‐120 according to
below position within 1‐3 inches
5
Setup Key
13
LED Indication Status
on ZXT‐120
• LED flashes once
when ZXT‐120
receives the
configuration
setting
‐
‐
• LED flashes once
when ZXT‐120
receives the
configuration
setting
• ZXT‐120 is ready to
learn
LED flashes twice if
learning is successful.
LED flashes 6 times if
it's failed.