Ir Code Learning - Remotec Z-Wave ZXT-120 User Manual

support heat, if user selected a code that does not support
heat but the original air conditioner supports heat function,
please continue to try next code until the correct one is
selected.

You can record down your device code for future reference
after setting up the ZXT‐120 correctly.
AC device programmed to your ZXT‐120
Code no.: _____________________________

If none of the code works on the target air conditioner, or the
air conditioner brand is not shown on the code list, please
select code "000" for IR code learning (refer to instruction of
IR Code Learning)
IR Code Learning
In case none of the code on the code list works for the targeted air
conditioner, user can use IR code learning function using configuration
according to below steps:
Step
Go to configuration setting page on
the gateway or ZRC‐100 and input
parameter number "27" and
1
parameter value "000" to select the
dedicated AC code number "000"
for learning.
Look up below mapping table (value
0‐22) for learning, and decide the IR
setting you intent to learn next.
For example "22°C, cool" which
matches value "5" (IR code to be
2
learnt will locate at "5" in ZXT‐120).
Set your original air conditioner
remote at "22°C, cool" and turn it
off. (Besides temperature and
mode, you may set other desired
settings, such as Fan, Swing etc.)
Go to configuration setting page on
the gateway or ZRC‐100 and input
parameter number "25" and
3
parameter value "5" (in this case).
Setup Key
10
LED Indication Status
on ZXT‐120
 LED flashes twice
when ZXT‐120
receives the
configuration
setting
‐
‐