Table of Contents
Advertisement
14
PHY Diagnostics Commands
test copper-port tdr
The test copper-port tdr Privileged EXEC mode command uses Time Domain
Reflectometry (TDR) technology to diagnose the quality and characteristics of a copper
cable attached to a port.
Syntax
test copper-port tdr interface
Parameters
•
interface — A valid Ethernet port. (Full syntax: unit/port )
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
The port to be tested should be shut down during the test, unless it is a combination port
with fiber port active.
The maximum length of the cable for the TDR test is 120 meter.
Example
The following example results in a report on the cable attached to port 3.
Console# test copper-port tdr ext.3
Cable is open at 64 meters
Console# test copper-port tdr ext.3
Can't perform this test on fiber ports
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
PHY Diagnostics Commands
153
Advertisement
Table of Contents
