Advertisement
System preparation (continued)
3 Slot in the sound bar to the base stand according to your
TV size.
60" TV
Slot in the wire inside the
groove or slit for better
wire arrangement.
Suggestion of the
sound bars and
LCD TV arrangement.
3. To mount the sound bar on the wall
1. Fix the brackets to the holes as shown.
(Model HT-SL77 : for 52", 60" and 70" TV)
(Model HT-SL72 : for 60" TV)
RIGHT
(Model HT-SL77 : for 46" TV)
RIGHT
Caution:
Be careful not to
fix the bracket
upside down.
2012 January 31
70" TV
Groove to neatly
arrange the wire in.
LEFT
LEFT
E-8
HT-SL72 / HT-SL77 ZBxxx
Caution:
●
Be very careful to prevent the sound bar and TX-BOX
from falling when mounting on the wall.
●
Before mounting, check the wall strength. (Do not put
on the veneer plaster or whitewashed wall. The sound
bar may fall.) If unsure, consult a qualified service
technician.
●
Mounting screws are not supplied. Use appropriate
ones.
●
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur or
the sound bar may get damaged.
SHARP is not responsible for accidents resulting
●
from improper installation.
●
Do not let children dangle on the sound bar and TX-
BOX once it is attached on the wall as it can cause
damage and injury.
Driving screws
SHARP designed the sound bar and TX-BOX so you may
hang them on the wall. Use proper screws (not supplied).
See below for size and type.
1/8" (3.2 mm)
3/16"
(5 mm)
3/8" (9 mm)
7/8" (Min. 22 mm)
Installing the sound bar
Fixing wall mount angle
1
Fix the pattern paper to the wall in horizontal
position as below.
Wall surface
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
1-1/4" (32 mm)
3/8" (8-9 mm)
Wall surface
3
Fix a wall mount plug (not supplied) into the hole
using a hammer, until it is flush with the wall
surface.
1-1/4" (32 mm)
3/8" (8-9 mm)
Wall surface
Pattern paper
Advertisement
