Char-Broil 463241704 Product Manual page 9

7
Remove the two screws and washers from the sideburner valve bracket.
Place sideburner valve under front of sideburner control panel so that
valve stem comes through large hole. Place sideburner bezel over valve
stem. Secure bezel to panel and valve using the two screws and
washers you removed from the valve bracket. Press control knob onto
valve stem.
Control
knob
80000035
Valve stem
Sideburner bezel
80000034
8
Insert sideburner into shelf, placing end of burner over sideburner
valve. Valve should be in center hole of burner tube.
illustration below for correct burner-to-valve engagement
sure pin on bottom of burner is in center hole in shelf bracket.
Insert short-threaded ends of
through holes in bracket and into burner. Wrench-tighten. Attach
ignitor wire to sideburner electrode. Align cup cut-out with
sideburner tube and holes in cup bottom with double-sided
screws. Place ignitor wire through burner tube cutout in cup.
Secure with 5mm flat washers (EEE) 5mm lock washers (FFF)
and #10-24 hex nuts (GGG)
Valve should be in center
hole in burner tube.
First, remove
screws and
washers from
bracket.
Sideburner
valve
See
double-sided screws (DDD)
,
.
Sideburner
80001698
. Make
Short
threads
DDD
Long
threads
Sideburner
Cup
EEE
FFF
GGG
Correct
burner-to-valve
engagement
Ignitor
Wire
463241704 • 9