The Lengthwise Movement Of The Feed Dog; The Bobbin-Winding Device - Husqvarna 1200 Service Manual

18 IV The lengthwise movement of the feed dog
Requirements
The feed dog must not strike against the
stitch plate when the machine is set at
maximum stitch length and speed.
Adjustment
Set the machine at stitch length 0 mm
and the feed dog at its highest position.
Loosen the screw (A) and shift the feed
dog until it comes in the middle of the
stitch plate.
Tighten the screw.
Check according to requirements.
NOTE!
Check that the stitch setting fork (B) is parallel with
the connecting rod (C) after tightening.

19 The bobbin-winding device

Limiting when bobbin-winding
Requirements
When bobbin-winding the machine shall stop when the
bobbin is full with thread up to approx. 1 mm from the
edge of the bobbin.
Adjustment
Loosen the locking ring (A) by means of a tool.
Thereafter turn the scanner (B) until you switch off
when there is an adequate amount of
thread on the bobbin (see illustration).
After the adjustment the scanner is secured from
being turned by means of the locking ring.
SEWKNITWORLD
104 72 30-26 Husqvarna service manual 35