Entering The Programming Mode - LG-Nortel ARIA SOHO Installation Manual

ARIA SOHO Hardware Description and Installation Manual
STARTING THE ARIA SOHO

6.2.2 Entering the Programming Mode

To enter programming mode, perform the following Steps:
1. Lift the Handset.
OR
2. 1. Press the [MON] button on the Admin Station; the ICM tone should be heard.
3. Press the [TRANS/PGM] button and dial * #; a confirmation tone should be heard.
4. Enter the Admin password if the password has been set; a confirmation tone should be heard
indicating that the Station is in Admin Programming mode.
5. Each program is accessed by pressing the [TRANS/PGM] button, the following should display:
6. Dial the desired three-digit program number. If an error is made while entering data, the
[TRANS/PGM] button will return to the previous status.
NOTE—To return to the previous state while Admin Programming, press the [CONF] button (clears the
temporary data fields).
6.2.2.1 Permanent Update Procedure
To accept changes while programming, perform the following Steps:
1. Press the [HOLD/SAVE] button when all changes have been entered to store the data permanently.
2. A confirmation tone should be heard when pressing the [HOLD/SAVE] button if all data was
entered correctly. If there were any errors in the entering of data, an error tone will be presented
and data will not be stored in the permanent memory.
6.2.2.2 Resetting the System
To reset the System, perform the following:
1. Enter [PGM] +450 then [FLEX] +15 and press the [HOLD/SAVE] button.
ENTER PGM NUMBER
46
Issue 1
Mar, 2007