Washing; Cere Care - BYD F6 Owner's Manual

BYD AUTO

Washing

Often washing vehicle is useful to its
appearance. The dust and grit can hurt the
paint, leaves and dung can damage the body
finish permanently.
Wash your vehicle in the cool place. Can't
wash it in the sun. If park your vehicle in
the sun for a long time, before washing it,
drive it to the cool place, when it gets cool,
wash it. Only use the solvent and cleanser
which are recommended in the ―owner's
manual‖.
Notice
Chymist solvent and strong cleanser
will hurt the paint, metal and plastic
parts.
Washing the engine chamber with high
pressure has bad hurt, not only hurt the
engine ECU, but also hurt sensor etc.
1. Wash your vehicle with cold water
thoroughly to remove floating dust.
2. Fill a barrel of cold water, mix special
cleanser into it.
3. Repeat wash your car with water,
cleanser and rub it with soft brush, sponge
or soft cloth from roof to bottom.
4. Check up whether there is ordure such as
pitch or tree liquid on the body. Remove the
ordure with pitch leaner or turpentine, then
wash it with clean water to avoid hurting the
body finish.
5. After finishing, rub it with soft cloth.
Naturally drying it will make the body lose
polish or form water mark.
Dry the body meanwhile checks up whether
there is the symbol of dropped paint or nick.
The position is easy to be eroded. If finding
it, repair it with the repair paint (refer to
th
139 page).

Cere care

Cering must be made after washing and
drying the vehicle. For preventing the body
appearance from accumulating
should cere the body and aglet. After
cereing, the accumulating
become the drip or bead.
136
F6 OWNER'S MANUAL
You should use the high quality liquid cere
or mushy cere. When using, you should
refer to the specfiction of container. There
are following two kinds of products：
Protection ceres—— coated on the paint to
protect it from sun shining and air polluting.
Should coat this cere on the new vehicle.
Polishing cere——it is the mixture of
polishing cere and cleanser or paraffin that
make the paint that is oxidized or lose
polish anew give off reflect. Generally
speaking, the cere includes soft rubbing
powder and solvent, it can remove the
surface layer of paint. If it can't make the
paint resume original reflect after cering the
protection cere, should coat the polishing
cere.
With cleanser removing the ordure such as
pitch and insect etc will cause dropping cere.
Notice: Even if the other parts needn't cere,
must anew cere on the parts which drop
water,
cere.
water will