Changing The Glass Fiber Yarn Filling Of The Main Silencer; Dismounting The Fuel Tank - KTM 65 SX 2013 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.27

Changing the glass fiber yarn filling of the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
Info
Over a period, the fibers of the insulating material vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.
11.28

Dismounting the fuel tank

Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See the notes on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
601948-11
Preliminary work
–
Remove the main silencer. (
Main work
–
Remove screws
–
Pull the glass fiber yarn filling
–
Clean the parts that are to be reinstalled.
–
Mount the new glass fiber yarn filling on the inner tube.
–
Slide the outer tube over the glass fiber yarn filling.
–
Insert the locking cap into the outer tube.
–
Mount and tighten the screws with the toothed washers.
700443-01
Guideline
Remaining screws, chassis
Final work
–
Install the main silencer. (
x
Preliminary work
–
Remove the seat. (
–
Turn the knurled screw on the fuel tap all the way clockwise.
.
4
x
p. 37)
of locking cap . Remove locking cap and outer tube
1 2
from the inner tube.
4
p. 37)
p. 35)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
38
.
3