14). Refer To The Inset Drawing. Make Sure That Each; The Thickest Part Of The Post - Pro-Form PFTL39101 User Manual

3. Slide a Rubber Ring (74) onto the post on each Upright

(14). Refer to the inset drawing. Make sure that each

Rubber Ring is turned so the tapered side is facing

the thickest part of the post.

4. Slide the upper end of a Handrail (2) and then the at-
tached Extension Leg (41) into the right Upright (14) as
shown. (Note: As you insert the Extension Leg, it may be
helpful to tip the Uprights [14] forward and tap the
Extension Leg with a mallet.) Tighten two of the four
Handrail Screws (13) into the Handrail.
Refer to the inset drawing. Tighten an Extension Leg
Screw (34) into the right Upright (14) as shown. Be sure
to push on the head of the Extension Leg Screw
while tightening it.
Attach the other Handrail (2) to the left Upright (14) as
described above.
5. With the help of a second person, carefully tip the
Uprights (14) down as shown.
Tighten the two Handrail Bolts (15) in the Extension Legs
(41). Refer to drawing 4. Make sure that the four Handrail
Screws (13) are tightened.
With the help of a second person, carefully tip the
Uprights (14) back to the upright position.
6. Attach the Storage Latch (12) to the left Upright (14) with
the Latch Spacer (23) and two Latch Screws (88). Be
careful not to overtighten the Latch Screws.
7. Make sure that all parts are tightened before you use
the treadmill. Keep the included allen wrench in a se-
cure place. The allen wrench is used to adjust the walk-
ing belt (see page 13). To protect the floor, place a mat
under the treadmill.
3
Post
74
Tapered Side
4
2
5
15
2
41
6
6
Post
14
74
14
13
14
2
14
34
15
41
14
23
12
88
13
14
41
14