Assembly; Unpack Pressure Washer; Attach Handle And Accessory Tray - Briggs & Stratton Pressure Washer Operator's Manual

Assembly

Read entire operator's manual before you attempt
to assemble or operate your new pressure washer.
Your pressure washer requires some assembly and is
ready for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer helpline
at (800) 743-4115. If calling for assistance, please have the
model, revision, and serial number from the identification
label available.

Unpack Pressure Washer

1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensure you have all included items prior to assembly.
Items in the carton include:
• Main Unit with cleaning tank
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Plastic Accessory Tray
• Oil Pouch
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Quick Connect 7-in-1 Nozzle
• Handle/Accessory Tray Fastening Hardware Kit
(which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Rubber Strap
• Tree Clips (4)
To prepare your pressure washer for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle and accessory tray to main unit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect 7-in-1 nozzle to nozzle
extension.

Attach Handle and Accessory Tray

1. Place handle (A) onto handle supports (B) connected
to main unit. Make sure holes (C) in handle align with
holes (C) on handle supports.
C
2. Insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E) from outside
of unit. Tighten by hand.
E
NOTICE By loosening both knobs to the unthreaded middle
section of the attachment bolt, the upper handle can fold
forward to store flat atop the cold engine. DO NOT fold the
handle down while the engine is hot.
3. Insert rubber strap (F) through slot (G) in back of
accessory tray and pull tight from front.
G
F
4. Place accessory tray (J) over holes (H) on handle
(viewing from front of unit). Push the tree clips (K) into
the holes until they sit flat against the accessory tray.
K
J
5. Insert supplied accessories in spaces provided in
accessory tray. See How to Use Accessory Tray.
A
C
B
D
H
7