Download Print this page

Parmco PD6-PWE Installation And Operating Instructions Manual page 16

Advertisement

'
Fuse blown, or the
circuit breaker acted
Power supply is not
turned on
Water pressure is low
'
Overflow
Some audible sounds are
normal
Utensils are not secure
in the baskets or something
small has dropped into
the basket
Improper detergent
Spilled rinse agent
Detergent with
colorant was used
Rinse agent dispenser
is empty
Improper program
Improper rack loading
Extremely hard water
Low inlet
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Empty rinse agent
dispenser
Incorrect dosage of
detergent
Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher
Make sure the dishwasher is turned on and the door is
closed securely.
Make sure the power cord is properly plugged into the
wall socket.
Check that the water supply is connected properly and
the water is turned on.
The system is designed to detect an overflow. When it
does, it shuts off the circulation pump and turns on the
drain pump.
Sound from soft food shredding action and detergent cup
opening.
To ensure everything is secured in the dishwasher.
Use only the special dishwasher detergent to avoid suds.
If this occurs, open the dishwasher and let suds evaporate.
Add 1 gallon of cold water to the tub. Close and latch the
dishwasher, then drain out the water by slowly turning the
Dial until a drain period is reached. Repeat if necessary.
Always wipe up rinse agent
spills immediately.
Make sure that the detergent is the one without colorant.
Make sure that the rinse agent dispense is filled.
Open door at end of program
Select stronger program
Make sure that the action of the detergent dispenser and
spray arms are not blocked by large dishware.
To remove spots from glassware:
Take out all metal utensils out of the dishwasher.
Do not add detergent.
Choose the longest cycle.
Start the dishwasher and allow it to run for about
18 to 22 minutes, then it will be in the main wash.
Open the door to pour 2 cups of white vinegar
into the bottom of the dishwasher.
Close the door and let the dishwasher complete
the cycle. If the vinegar does not work: Repeat
as above, except use 1/4 cup (60 ml)of citric acid
crystals instead of vinegar.
13

Advertisement

loading

This manual is also suitable for:

Pd6-pse