Download Print this page

Parmco PD6-PWE Installation And Operating Instructions Manual page 12

Advertisement

A forgotten dish can be added any time before the detergent cup opens.
1
Please press the start button.
2
Do not open the door until the water spray action stops.
Steam may rise out of the dishwasher.
For your convenience, we have placed the drain pump and filtering system within easy reach inside the tub. There are three
components in the filtering system: the main filter, the coarse filter, and the fine filter.
2
1
3
If your dishwasher is left in an unheated place during the winter, ask a service technician to:
1
Cut off electrical power to the dishwasher.
2
Turn off the water supply and disconnect the water
inlet pipe from the water valve.
3
Drain water from the inlet
(Use a pan to catch the water.)
1
Main filter
Food and soil particles trapped by this fil ter are pulverized by a special jet on the lower spray
arm and washed down the drain.
2
Coarse filter
Larger items, such as pieces of bone or glass, that could clog the drain are trapped in the
coarse filter. To remove an item caught in this filter, gently squeeze the tabs on top of this
filter and lift it out.
3
Fine filter
This filter holds soil and food residue in the sump area and prevents it from being
redeposited on the dishes during a cycle.
pipe
and water valve.
It is necessary to clean the spray arms regularly , as hard water chemicals will clog the
spray arm jets and bearings. To remove the spray arm, screw off the nut clockwise take
out the washer on top of the spray arm and remove the arm. Wash the arm in soapy
warm water and use a soft brush to clean the jets. Replace after rinsing thoroughly.
Filter assembly
For best performance and results, the filter assembly must be cleaned.
The filter efficiently removes food particles from the wash water, allowing it to be
recirculated during the cycle. For this reason, it is a good idea to remove the larger
food particles trapped in the filter after each wash cycle by rinsing the se micircular
filter and cup under running water. To remove the filter assembly, pull on the cup
handle in the upward direction. The entire filter assembly should be cleaned
once a week.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble
the filter parts as shown in the figure left.Reinsert the entire assembly in the
dishwasher, positioning
The dishwasher must never be used without the filters. Improper replacement of the
filter may reduce the performance level of the appliance damaging dishes and utensils.
3
Add forgotten dishes.
4
Close the door and Press the Start button to start washing.
4
Reconnect the water inlet
water valve.
5
Remove the filter from the tub the bottom
and use a sponge to soak up water
in the sump.
in it's seat and pressing downward.
9
pipe
to the

Advertisement

loading

This manual is also suitable for:

Pd6-pse