Table of Contents
Advertisement
Titan Neo
TRANSMITTER/MICROPHONES
product description
UT-96HH Transmitter Microphone Operation
Be sure the microphone is switched off before
1.
inserting batteries.
Remove lower identity cap.
2.
Remove lower battery compartment door.
3.
Insert two (2) AA batteries (use only alkaline
4.
or fully charged NiMH batteries).
Caution: Be sure to observe correct polarity
Replace lower battery compartment door.
5.
Locate power switch at base of microphone
6.
(small gray button)
Press upward and hold the power switch for 2-3
7.
seconds.
Power LED will illuminate "Red" and "On" will
8.
be displayed in the LCD screen.
LCD window will also display: Battery condition
9.
and CH #
A microphone sensitivity selection switch
10.
provides three modes of microphone sensitiv-
ity (HIGH, LOW, MUTE).
• MUTE: Mutes microphone "off" while
retaining transmission and RF connection.
• LOW: Use when microphone is held close
to mouth or strong vocal input.
• HIGH: Use when additional sensitivity is
required for softer voice.
LCD screen displays the channel number
11.
selected for the microphone. To display chan-
nel frequency: Press and hold the UP or DOWN
select button.
To change channel selection
12.
• Press and hold frequency SET button for
2 seconds. LCD panel will commence
flashing (indicating programming mode)
• Press UP or DOWN arrow to select channel
desired
• Press SET button to lock in channel
selected
26
Danger
DO NOT ATTEMPT TO
CHARGE ALKALINE
BATTERIES
FCC Regulation
RF transmission
equipment must comply
with FCC regulations. All
TeachLogic transmission
devices comply with Part
15 of the FCC rules and
operate in the UHF band
in the 640–664 MHz
frequency range. Power
output is limited to less
than 50 milliwatts to
prevent any interference
with any other RF
operated equipment.
Advertisement
Table of Contents
