Page 2
Titan Neo INTRODUCTION product description Notes Date of Purchase: Model Number: Serial Number: Notes:...
Page 3
Congratulations on the purchase of your new Titan Neo Sound System. You can be assured that the Titan Neo was produced to high quality standards and will fulfill all its specifications. TeachLogic incorporated the latest state of the art technol-...
Page 4
Titan Neo INTRODUCTION product description Safety Instructions Read Instructions All safety and operation instructions should be read before operating this TeachLogic product. Retain Instructions Safety and operating instructions should be kept for future reference. Water & Moisture Certifications This product should not be operated near water or excessively moist area.
Owner’s Manual INTRODUCTION Table of Contents Introduction ..............i–7 Titan Neo Components & Operation General Description 8–10 Input Panel 11–12 DR-800 Auto Scan Receiver CD-800S CD/MP3 Player 15–19 CD/MP3 Remote Control 20–21 TX-800 Transmitter Module PA-810 Companion Speaker DD-750 Digital Delay Module 24–25...
Page 6
Titan Neo INTRODUCTION product description About RF Transmission Through today’s technology and advanced engi- neering, wireless microphones reproduce excel- lent vocal quality and render very reliable service. Thus today, the use of wireless microphones is commonplace. The convenience of no cumber- some cables and freedom of movement has made the wireless microphone very convenient to use.
Owner’s Manual INTRODUCTION About the Titan Neo The Titan Neo is a compact portable sound system for music playback and voice reinforcement. It is powered by internal batteries and housed in a rugged enclosure. The lightwieght, compact size makes the Titan Neo very versatile and practical for use on all occasions, indoors or out.
Titan Neo Titan Neo COMPONENTS & OPERATION product description Titan Neo Rear Optional DR-800 Receiver Modules Power Switch Optional CD/MP3 Player Module Main Control Panel Optional TX-800 Transmitter Module Charge Indicator Light 110–240v AC Input...
Page 9
The DD-750 module is a delay module that can store a signal received for 20–500 milliseconds, selectable in 2 millisecond increments. The program sig- nal is transmitted from the Titan Neo through the TX-800 AirLink Module to the companion system equipped with the DD-750 delay module. The signal is digitally stored in the DD-750 per the delay time selected and then released through the companion sound system.
Page 10
Titan Neo COMPONENTS & OPERATION Before Using the Titan Neo It is best to plug the Titan Neo into an AC outlet and restore batteries to full charge condition. Although the batteries were checked and fully charged prior to shipment, NiMH batteries have a tendency to lose some charge when not in use.
Page 11
Titan Neo COMPONENTS & OPERATION Main Control Panel The main control panel is the basic panel for all Titan Neos and Titan Neo companions. It houses the master volume control, hardwired microphone in- put, auxiliary input, record output, mic & line volume controls, tone controls and the unique “Voice Priority”...
Page 12
Titan Neo Titan Neo COMPONENTS & OPERATION Main Control Panel Master volume adjusts overall system level from all inputs (i.e.: UHF, CD/ MP3 player, RCA stereo input and wired microphones). Treble and bass controls affect all system inputs, when set to half way sound output will be flat.
Page 13
Titan Neo COMPONENTS & OPERATION DR-800 Auto Scan Receiver for Wireless Microphone One or two auto scan receiver modules can be installed in the Titan Neo. Each receiver has 96 selectable channels to assure interference-free operation and is equipped with a diversity antenna for added sensitivity.
Page 15
Owner’s Manual Titan Neo COMPONENTS & OPERATION CD-800S Player This anti-shock CD/MP3 player allows playback of both standard CD’s and data CD’s containing MP3 or WMA files. POWER PLAY/ SB/USB FOLDER PAUSE STOP/EJ To operate, push the power button. Insert a CD into the CD slot and press play/ pause button.
Page 16
Titan Neo Titan Neo COMPONENTS & OPERATION product description CD-800S Player Functions POWER PLAY/ SB/USB FOLDER STOP/EJ PAUSE POWER • ON: Press Power to switch on the power. • OFF: Press and hold Power to switch off the power. LCD DISPLAY Displays CD status including track number and playing time.
Page 17
Owner’s Manual Titan Neo COMPONENTS & OPERATION CD-800S LCD Display CD When in CD mode, the display panel shows “Cd”. USB When in USB mode, the display panel shows “USb” SD When in SD mode, the display panel shows “Sd”...
Page 18
Titan Neo Titan Neo COMPONENTS & OPERATION Playing CD-800S POWER PLAY/ SB/USB FOLDER STOP/EJ PAUSE • This player will accept 4.75” (12 cm) discs like CD, CD-R, CD-RW, MP3, USB and SD / MMC memory cards, but will not play CD-ROM / CD-I / CDV, or 3”...
Page 19
Owner’s Manual Titan Neo COMPONENTS & OPERATION Playing SD/MMC Card • Insert SD Card or MMC Card into the insert hole of SD/MMC CARD in the face plate. Push the card into the SD/MMC card slot. To remove the card, please push the card to the bottom and then release. Please do not use force to pull card out.
Page 20
Titan Neo Titan Neo COMPONENTS & OPERATION product description Remote Controller Functions EJECT Press to stop playing and eject the disc. can memorize a set of tracks for playback. PROG To Program a set of tracks: 1) Insert a disk into the CD player, press key one time.
Page 21
Owner’s Manual Titan Neo COMPONENTS & OPERATION Remote Controller Functions PITCH EJECT HIGH PROG FOLDER A–B Note USB/SD When using the remote control, the remote should be pointed toward the face plate of the CD/ MP3 Player. The optimal receiving distance is 10 feet.
Titan Neo Titan Neo COMPONENTS & OPERATION product description TX-800 Transmitter Module For larger venues or audiences, the addition of this module allows several units to be used in the same area without the need for speaker or signal wiring. In this application you have a master and as many slave units as required for the venue.
Companion Speaker The PA-810 is an AC or battery powered Companion System with a 96 Channel Wireless Receiver for a wireless connection from a Titan Neo Sound System with the TX-800 Wireless Transmitter installed. The PA-810 can also be utilized as a self contained battery powered PA system with the use of a hardwired handheld microphone (UM-66), or wireless micro- phone (UT-96HH or UT-96BP).
Page 25
Owner’s Manual Titan Neo COMPONENTS & OPERATION To Set The Time Delay Depress the power switch. The LCD screen will display the last saved delay time. To change the delay time select the “SET” button. Using the UP/ DOWN time delay adjustment buttons, set the de- lay to the desired time in milliseconds.
Titan Neo TRANSMITTER/MICROPHONES product description UT-96HH Tranmitter Microphone Description The handheld microphone/transmitter is equipped with a dynamic microphone element for enhanced clarity and extended dynamic range. Its low handling noise and built-in windscreen makes it well suited for close-up handheld use.
Page 27
Owner’s Manual TRANSMITTER/MICROPHONES UT-96HH Tranmitter Microphone Operation Be sure the microphone is switched off before inserting batteries. Remove lower identity cap. Remove lower battery compartment door. Insert two (2) AA batteries (use only alkaline or fully charged NiMH batteries). Caution: Be sure to observe correct polarity Replace lower battery compartment door.
Page 28
Titan Neo TRANSMITTER/MICROPHONES product description UT-96HH Tranmitter Microphone Operation The battery status is displayed on the left of the LCD screen. • When battery nears depletion: Icon will flash 3 times. • Microphone will automatically turn “off” to prevent damage.
Page 29
Titan Neo UT-96BP Body-Pack Tranmitter Description The Body-Pack Transmitter is the component that transmits the voice to the Titan Neo receiver. The audio is transmitted via an RF signal on a selected RF frequency. An external microphone is plugged into the Body-Pack Transmit- ter which picks up the speaker’s voice.
Page 30
Titan Neo TRANSMITTER/MICROPHONES product description UT-96BP Body-Pack Tranmitter Operation Ensure microphone is switched off before inserting batteries. Remove battery compartment cover. Insert two “AA” batteries, observing polarity (alkaline or rechargeable NiMH). Plug in microphone: Lapel, Headset w/boom, Collar or UltraLite mic.
Page 31
To turn microphone “Off”; push power switch to "OFF". FCC Regulation RF transmission equipment must comply with FCC regulations. All TeachLogic transmission devices comply with Part 15 of the FCC rules and operate in the UHF band in the 640–664 MHz frequency range. Power...
Page 32
Titan Neo TRANSMITTER/MICROPHONES product description Optional Microphones for Body-Pack Transmitter Any of the microphones below may be used with the Body-Pack Transmitter. LM-835 Lapel Microphone The Lapel Microphone (LM-835) is a small capsule microphone with a spring clip for securing it on to a clothing edge.
Titan Neo BATTERY CHARGERS product description BRC-10 Plug-In Charger The BRC-10 charger is designed to charge the UT-96HH Handheld Transmitter/Microphone. Operating Instructions • Use “AA” rechargeable NiMH batteries only • Plug adapter into 110v AC outlet. • Remove color identification cap. • Plug cable into jack at the base (bottom end) of transmitter • Turn Handheld Transmitter “On”...
Page 35
Owner’s Manual BATTERY CHARGERS product description BRC-70 Drop-In Charging Dock The BRC-70 charger is designed to charge the UT-96HH and/or UT-96BP Body-Pack Transmitter. Operating Instructions • Use “AA” rechargeable NiMH batteries only in microphones • Plug power adapter in 110v AC outlet. • Plug cable into base of charger • Charging Handheld Microphone/Transmitter •...
Titan Neo TROUBLESHOOTING product description UT-96HH Transmitter Microphone Problem Solution Power LED does not • Check batteries are illuminate after press- charged and inserted ing power switch correctly. When press- ing power switch ensure you hold it down for 2–3...
Page 37
Owner’s Manual TROUBLESHOOTING product description UT-96HH Transmitter Microphone Problem Solution Interference and • Make sure there are no Signal disturbance other wireless systems operating on the same frequency in the same area. This includes Microphones, Televisions, Radio Stations, etc. • When operating two transmitters in the same area, ensure frequencies selected are several...
Page 38
Titan Neo TROUBLESHOOTING product description UT-96BP Body-Pack Tranmitter Microphone Problem Solution Power LED does • Check batteries are not illuminate after charged and inserted switching on correctly. LCD panel displays • Check frequency of trans- garbled information mitter is the same as the portable PA receiver •...
Page 39
Owner’s Manual TROUBLESHOOTING product description Sorting out LCD ERR message The ERR message may show up on the units UT-96HH, UT-96BP, DR-800 and TX-800. In brief, any wirelessbased devices that carry a LCD panel might have this potential problem. The feasibility of such kind of rick shall be quite few, but it might occur.
Page 41
Owner’s Manual TROUBLESHOOTING Channel Selection in a Given Area and Simultaneous Use of Multiple Channels. Transmission by wireless microphones and low power audio transmitters may encounter various interference problems. Interference may be caused by local area TV or commercial broadcast institutions. In addition, interference can be due to wireless receivers and transmitters used simultaneously in close proximity to each other.
Page 42
Titan Neo TROUBLESHOOTING product description Channel Frequency Allocation 640–664 MHz LCD UHF TV Frequencies TV Channel 638–644 644–650 650–656 656–662 662–668...
Carrying case holds PA-700 speaker with opening for handle & side storage pocket for transmitters, etc. SS-750 Heavy Duty Speaker Stand Heavy duty speaker stand for Titan Neo sound system. Folding tripod adjustable height from 30" to 60". HT-175 Mini Mover Handtruck Superlite folding hand truck.
Titan Neo SPECIFICATIONS product description Portable PA System Output Power 50 W RMS, 80 W Max Sensitivity 91dB, 1W @ 1M Maximum SPL 95 dB Frequency Response 20 Hz - 20 kHz (audio) Speaker 8" LF Neodymium Woofer 1" HF Horn Signal to noise Ratio >70dB...
Page 47
Owner’s Manual SPECIFICATIONS product description DR-800 Wireless Receiver Dimensions 3 ½" W x 1.5" H x 5" D Weight 4 oz. product description TX-800 Wireless Transmitter Dimensions 7 ½" W x 1 3/16" H x 4" D Weight 10 oz. CD/MP3R Player product description Formats...
Page 48
Titan Neo SPECIFICATIONS UT-96HH Handheld Transmitter Microphone Mic Capsule Dynamic RF Output 10mW Spurious Emission 250mW AF Controls Hi/lo/mute switch Battery 1.2V NiMH rechargeable x 2 or 1.5V Alkaline x 2 Operating Life (fully 11 hrs (NiMH) or 14 hrs...
Owner’s Manual WARRANTY Three Year Limited Warranty TeachLogic RF products are guaranteed to be free of defects in workmanship or material for a period of three (3) years from date of original purchase, subject to the following conditions: 1. Warranty excludes defects caused by normal use and wear, any abuse, or failure to use the product in accordance per instructions.
Page 52
TeachLogic, Inc. 1688 Ord Way Oceanside, CA 92056 0018 • • • sales@teachlogic.com 1283 • • • 5/13 www.teachlogic.com...