Page 1
OWNER’S MANUAL MODEL GA52F32 RETURN GRILLE MOUNT ELECTRONIC AIR CLEANER IMPORTANT: PLEASE READ MANUAL BEFORE OPERATING UNIT Features Lifetime Filter System never needs replacing Electronically removes dust, mites, pollen, pet dander, tobacco smoke, cooking smoke and grease, mold, fungi, bacteria, and more down to 0.01 micron...
IMPORTANT: Please read entire instructions before WARNING installing, cleaning or repairing the Electronic Air Cleaner. Before beginning any installation or modification, be certain CONTENTS that the main line electrical disconnect switch is in OFF position. Electric shock could result. Tag disconnect switch SAFETY CONSIDERATIONS with suitable warning labels.
Second, charged particles move into the collecting area installed to the main return duct. For the unit to perform where they are attracted to a series of grounded plates. properly, all the return air must pass through the Pollutants are held in this section like a magnet until Electronic Air Cleaner.
speed motor drops the air flow to a point the sensor will through the ducts. The Air Cleaner will not run if the not activate the power board. system fan is off. For proper operation, follow these simple steps: Installation 1.
approximately 12-24 hours. A hair dryer may be used proper operation, turn the unit on and activate. The power to speed up drying time. board should come on immediately, and then turn off within 30 seconds as the sensor heats up. When the 6.
Maximum Voltage power board. on Plates (KVDC) on Ionizer (KVDC) 4. Turn the Air Cleaner ON. Measure voltage across GA52F32 4.6 - 4.8 (HV1) 7.0 - 7.3 (HV2) leads with a voltmeter. Voltage should read 24 - 28 VAC. Table 1 — Power Board Voltage Settings...
7. Turn OFF the Air Cleaner. A high voltage meter should be used. If one is not available, this method can be used. This will only set an 8. Remove the high voltage meter. approximate voltage. After using this method, the voltage 9.
4. Using needle-nose pliers, place spring hook in the MODEL GA52F32 hole of the ionizing bar near cell top. HOUSE SIZE 5. Place eyelet of wire over the S-hook and place S-hook into hole on ionizing bar on other side of cell.
Fig. 8 — Exploded View and Parts List Description Part Number Description Part Number Front Grill EACGM-01 11 Electrical Cover EACGM-11 Thumb Screw EACGM-02 12 Air Switch Assembly with Slider EACGM-12 Prefilter EACGM-03 13 24 Volt Transformer EACGM-13 Collecting Cell EACGM-04 14 Power Board EACGM-14...
Table 3 — TROUBLESHOOTING GUIDE PROBLEM PROBABLE CAUSE REMEDY System fan is not on. Turn system fan on. Wiring improperly connected. Check wiring. Unit does not function correctly. Power Defective power switch. Check power switch for continuity with multimeter. Replace if defective. switch on and Defective safety interlock.
Any questions pertaining to this limited warranty should be addressed to General Filters, Inc. General Filters, Inc. has elected not to make available the informal dispute settlement mechanism which is specified in the Magnuson-Moss Warranty Act. GA52F32-1A.PUB 08/11...
Page 12
ATTENTION INSTALLER IMPORTANT WIRING INFORMATION This Electronic Air Cleaner is equipped with an Air Proving Switch (APS). The recommended source for the input voltage to the Air Cleaner is from the same source that is supplying the heating/cooling equipment, providing it is the same voltage as the Air Cleaner.