How To Adjust A Setting; Adjusting The Picture - AOC Spectrum 7Vlr User Manual

HOW TO ADJUST A SETTING

1. Press the Shuttle Knob or OSD Key to make the OSD window appear.
See figure 4.
2. Rotate the Shuttle Knob to select the desired function. See figure 4.
3. Press the Shuttle Knob again to select the function that you want to
adjust.
4. Rotate the Shuttle Knob to change the settings of the current function.
5. When the OSD window is active, it shows the input signal timing. The
"H" stands for the horizontal frequency and "V" for the vertical frequency.
6. To exit and save, either press the OSD Key, select the exit function, or
leave the monitor alone for 10 seconds. If you want to adjust any other
function, repeat steps 2-4.

ADJUSTING THE PICTURE

The description for function control LEDS
1. CONTRAST
2. BRIGHTNESS
3.
H- CENTER
4. H- SIZE
5. V- CENTER
H: 68.8KHz
Contrast
70
9300
Figure 4 The OSD Message
Adjust the picture contrast.
Adjust the picture brightness.
Adjust the horizontal position of the picture.
Adjust the picture's horizontal size.
Adjust the vertical position of the picture.
7
V: 85Hz
6500