Andrew 9.3-Meter ESA Installating And Operation Manual page 37

Step 7
Refer to Figure 35. Raise preassembled subreflector subassembly and strut assembly
and attach to subreflector supports as shown.
•
Use 1/2 x 2-1/2 in (64 mm) galvanized bolts, flat washers, lock washers and nuts.
Step 8
Securely tighten mounting hardware. Mount tabs on strut assemblies to right side of
subreflector brackets to keep struts aligned with corresponding reflector segment sec-
tions.
Figure 35
37
Installation Procedures