Table of Contents
Advertisement
Azimuth Jack
Screw Assembly
Step 1
Step 2
Refer to Figure 17. Apply RTV to flange surface and attach 200013-4/301841 azimuth
jackscrew to 201021 azimuth pivot assembly as shown.
•
Use 1-1/4 by 3-1/2 in (89 mm) bolts, lock washers and nuts
Note: Mounting hardware is included with corresponding jack assembly hardware kit.
Attach 200131 azimuth jack extension to 200013-4 azimuth jack screw (manual, low- and
medium-speed applications only) as shown.
•
Use 7/8 by 2-3/4 inch (70 mm) bolts, flat washers and nuts.
Note: Type 301841 azimuth jack screw is used only for high-speed applications.
Figure 17
22
Installation Procedures
Advertisement
Table of Contents
