High-Beam On Light; Cruise Control Light; Information Displays Driver Information Center (Dic) (With Dic Buttons); Driver Information Center - Chevrolet Traverse 2013 Owner's Manual

Hide thumbs Also See for Traverse 2013:
Table of Contents

Advertisement

Chevrolet Traverse Owner Manual - 2013 - crc - 8/20/12
This light is also used to indicate the
status of the anti-theft alarm system
when the ignition is turned off. The
light will flash rapidly if the alarm
system is arming and one or more
of the monitored entry points is not
closed. The light will stay on if the
alarm is arming and all entry points
are closed.
For information regarding this light
and the vehicle's security system,
see Vehicle Alarm System on
page 2 11.

High-Beam On Light

The high-beam on light comes on
when the high-beam headlamps are
in use.
See Headlamp High/Low-Beam
Changer on page 6 2 for more
information.

Cruise Control Light

This light comes on whenever the
cruise control is set.
The light goes out when the cruise
control is turned off. See Cruise
Control on page 9 29 for more
information.
Black plate (23,1)
Instruments and Controls
Information Displays

Driver Information Center

(DIC) (With DIC Buttons)
If your vehicle has DIC buttons, the
information below explains the
operation of this system.
The DIC displays information about
your vehicle. It also displays
warning messages if a system
problem is detected.
All messages will appear in the DIC
display located at the top of the
instrument panel cluster.
The DIC comes on when the ignition
is on. After a short delay, the DIC
will display the information that was
last displayed before the engine
was turned off.
The DIC also displays a shift lever
position indicator on the bottom line
of the display. See Automatic
Transmission on page 9 21 for more
information.
5-23

Advertisement

Table of Contents
loading

Table of Contents