Chevrolet Traverse 2013 Owner's Manual page 123

Chevrolet Traverse Owner Manual - 2013 - crc - 8/20/12
To calibrate the compass, use the
following procedure:
Compass Calibration Procedure
1. Before calibrating the compass,
make sure the compass zone is
set to the variance zone in which
the vehicle is located. See
Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration procedure.
2. Press the vehicle information
button until PRESS
CALIBRATE COMPASS
displays.
3. Press the set/reset button to
start the compass calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle in
tight circles at less than 8 km/h
(5 mph) to complete the
calibration. The DIC will display
CALIBRATION COMPLETE for a
few seconds when the
calibration is complete. The DIC
display will then return to the
previous menu.
Clock (Radio without
Touchscreen)
To adjust the time and date:
1. Turn the ignition key to ACC/
ACCESSORY or ON/RUN, then
press to turn the radio on.
2. Press to display HR, MIN,
MM, DD, YYYY (hour, minute,
month, day, and year).
TO
3. Press the pushbutton located
under any one of the labels to be
changed.
4. To increase the time or date, do
one of the following:
Press the pushbutton below
the selected label.
Press
Instruments and Controls
5. To decrease the time or date, do
one of the following:
To change the time default setting
from 12 hour to 24 hour or to
change the date default setting from
month/day/year to day/month/year:
1. Press
pushbutton located under the
forward arrow that displays on
the radio screen until the time
12H (hour) and 24H (hour), and
the date MM/DD (month and
day) and DD/MM (day and
month) display.
2. Press the pushbutton located
under the desired option.
SEEK.
Black plate (7,1)
5-7
Press FWD.
Turn clockwise.
Press SEEK.
Press REV.
Turn counterclockwise.
and then the