Connecting Onkyo Components; Connecting A Recording Component - Onkyo HT-R391 Instruction Manual

Connecting Onkyo Components
1
Make sure that each Onkyo component is
connected with an analog audio cable (connection
in the hookup examples) (➔ page
2
Make the connection (see the illustration).
3
If you're using an RI Dock or cassette tape deck,
change the Input Display (➔ page
With (Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
, the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver's remote controller to
control your other -capable Onkyo components,
pointing the remote controller at the AV receiver's
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(➔ page 50).
17).
35).
e.g., cassette tape deck
Note
• Use only cables for
with Onkyo components.
• Some components have two
one to the AV receiver. The other jack is for connecting
additional -capable components.
• Connect only Onkyo components to
manufacturer's components may cause a malfunction.
• Some components may not support all
manuals supplied with your other Onkyo components.
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
RI Dock
connections. cables are supplied
jacks. You can connect either
jacks. Connecting other
functions. Refer to the
En-18

Connecting a Recording Component

See "Recording" for details on recording
L
AUDIO
IN
VCR, DVD recorder,
cassette tape deck,
CDR, MD recorder, etc.
Note
• The AV receiver must be turned on for recording. Recording is
not possible while it's in standby mode.
• If you want to record directly from your TV or playback VCR to
the recording VCR without going through the AV receiver,
connect the TV/VCR's audio and video outputs directly to the
recording VCR's audio and video inputs. See the manuals
supplied with your TV and VCR for details.
• Video signals connected to composite video inputs can be
recorded only via composite video outputs. For example, if your
TV/VCR is connected to a composite video input, the recording
VCR must be connected to a composite video output.
• The surround sound and DSP listening modes cannot be recorded.
• Copy-protected Blu-ray Discs and DVDs cannot be recorded.
• Sources connected to a digital input cannot be recorded. Only
analog inputs can be recorded.
• DTS signals will be recorded as noise, so don't attempt analog
recording of DTS CDs or LDs.
Connections
(➔ page 36).
R
VIDEO
IN