Checking And Lubricating The Cables - Yamaha Grizzly 80 YFM80GW Owner's Manual

1. Rubber cap
2. Locknut
3. Adjusting bolt
NOTE:
Turning the adjusting bolt in decreases clutch free
play and turning it out increases clutch free play.
5. Tighten the locknut to the specified torque.
Tightening torque:
Locknut:
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
NOTE:
When tightening the locknut, hold the adjusting
1 2
3
bolt with a screwdriver so that the adjusting bolt
does not turn together with the locknut.
6. Install the rubber cap securely.
7. Install the left footboard by installing the
screws and bolts, and then tighten the bolts to
the specified torque.
Tightening torque:
Footboard bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
EBU24890

Checking and lubricating the cables

The operation and the condition of all control ca-
bles should be checked before each ride, and the
cables and cable ends should be lubricated if nec-
essary. If a cable is damaged or does not move
smoothly, have a Yamaha dealer check or replace
it.
Recommended lubricant:
Engine oil
8-29
1
2
3
4
5
6
7
8
9
10
11