Table of Contents
Advertisement
3
Check [Use DHCP/BOOTP] or [Use RARP] in the TCP/IP
setting window and click [Setup].
4
If the settings are correct, click [Yes]. The settings are
transmitted to the Fast EtherNet.
At this point, the Fast EtherNet is still operating with
the previous settings.
User Manual
5
To make the new settings take effect, click [Yes].
If you select [NO], the new settings will take effect
when the printer is turned off and then back on again.
You may need to power cycle the printer depending
on the model.
153
Advertisement
Table of Contents
