Table of Contents
Advertisement
TCP/IP setup screen
1
Set whether TCP/IP is used.
2
Enter the IP address in the format: "###.###.###.###".
3
Check here if IP address is to be acquired from RARP or
DHCP/ BOOTP.
4
Enter the subnet mask in the format: "###.###.###.###".
5
Enter the gateway address in the format: "###.###.###.###".
If you do not use a router or gateway, enter "0.0.0.0".
6
Enter the ROOT password.
136
SNMP setup screen
1
Enter the authentic community name and trap community
name.
2
Enter IP address for trap address as "###.###.###.###". If
you do not use traps, enter "0.0.0.0".
3
Enter SysContact, SysName and SysLocation.
4
This is the IP packet TTL value. This should not normally
be changed.
5
Check this option if a trap is to be issued in cases of
authorisation error.
Fast Ethernet
Advertisement
Table of Contents
