Table of Contents
Advertisement
Using SNMP
The Fast EtherNet is equipped with an SNMP agent which runs
on UDP. The printer can be controlled using an SNMP Manager.
The Fast EtherNet supports SNMPv1, MIB-II and OKI Data
Private MIB. For OKI Data Private MIB, please use the file
appropriate to your printer, referring to "readme.txt" in the MIB
folder on the "Fast EtherNet CD- ROM".
The default values for SNMP settings are as follows:
The default values for printer trap settings are as follows.
140
Fast EtherNet settings
The Fast EtherNet parameters and their values are described
bellow.
Some functions may not be used, depending on your printer
type.
The settings in Italics indicates Fast EtherNet default settings
IItems
Function
TCP/IP
otocol is used for Ethernet Board.
TCP/IP protocol
Set TCP/IP Protocol for Ethernet Board.
Set IP Address for Ethernet Board. Enter
IP address
the value in a decimal system as
"***.***.***.***".
For RARP or DHCP/BOOTP, IP Address
setting is not required because it will be set
dynamically.
Set Subnet Mask for Ethernet Board. Enter
Subnet mask
the value in a decimal system as
"***.***.***.***".
Gateway address
Set Gateway Address for Ethernet Board.
Enter the value in a decimal system as
"***.***.***.***".
RARP protocol
Set whether RARP requirement (i.e.dynamic
IP Address acquisition) is conducted at
Printer start-up.
DHCP/BOOTP
Set whether DHCP or BOOTP requirement
protocol
(i.e. dynamic IP Address acquisition) is
conducted at Printer start-up.
ROOT password
Set the root user password needed to
change Ethernet Board settings using
TELNET or other utilities. Enter the
password in 7 alphabets or numbers
Setup Value
ENABLE : To use thefunction.
DISABLE: Not to use the
function.
Default value
0.0.0.0.
Default value
0.0.0.0.
Default value
0.0.0.0.
ENABLE : To use the function.
DISABLE: Not to use the
function.
ENABLE : To use the function.
DISABLE: Not to use the
function.
Default value
None.
Fast Ethernet
Advertisement
Table of Contents
