Table of Contents
Advertisement
Items
Printer type
Set Printer type for KANJI filter.
Designate the character width to convert a tab code
TAB size
(0x09) into a half space (0x20), when outputting data via
KANJI filter. If the width is set to 0, the tab transformation
will not be conducted. The value may vary from 0 to 16.
Set the page width when outputting via KANJI filter. The
Page width
value may vary from 0 to 255.
(letters in a line)
Set the page length when outputting via KANJI filter. The
Page length
value may vary from 0 to 255.
(lines in a page)
Select whether a banner page is output when printing with
Banner output
LPR or FTP. This setting is valid only for TCP/IP protocol.
Printer Trap
Set whether Printer Trap is used.
Trap enable
Set the Local Trap and Global Trap.
Trap type
Trap address(UDP)
Set the Trap Notice Address for UDP. Enter it in a
decimal system as "###.###.###.###". When IP Address
is 0.0.0.0, the trap will not be issued.
Trap address(IPX)
Enter the Trap Notice Address for IPX. Enter it as
"Network Address (8 digits)+ Node Address (12 digits)".
When it is 00000000:000000000000, the trap will not be
issued.
Status
Ready
Printer is on-line and ready to receive print data.
Offline
Printer is off-line.
Printer Error
Some printer error is caused. "Warming up" means
Printer is getting ready for printing. Please wait for a
moment.
User Manual
Function
Setup Value
Fixed as PS(PostScript).
Default value
8
Default value
78
Default value
66
YES : With Banner page
NO : Without Banner page
ENABLE : To use this function.
DISABLE : Not to use this
function.
LOCAL
UDP
IPX
Default value
0.0.0.0
Default value
00000000:
000000000000
Note
Please confirm the message
on Printer LCD.
143
Advertisement
Table of Contents
