Media Operation - Skoda Bolero Owner's Manual

Incoming traffic announcement
When a traffic announcement is being received, a pop-up window will open.
If you wish to interrupt the transmission of the traffic announcement, press on the
function key in the pop-up window Traffic announcement. The traffic
Cancel
programme function remains available and a following traffic announcement is
made again while the audio mode is in operation. Pressing the function key
TP deactivated will switch off the traffic programme function permanently.
Traffic information memory
Automatic recording of traffic reports
If the traffic information function is switched on and a traffic information station is
received, the incoming traffic reports will be recorded, as long as the ignition is
switched on. This way you are informed at any time of the current traffic situation,
even if you have your radio switched off for a lengthy period while driving.
If the vehicle is not in use (ignition off) while a traffic information station is received
and the traffic information function is switched on, incoming traffic reports from
this station are recorded for two hours.
When switching the ignition off the current traffic information station is displayed
for about five seconds, from which the next two hours of traffic reports will be
recorded. During this display of five seconds, you can select another traffic informa-
tion station using the arrow keys on the unit, which will be recorded.
If, when the vehicle is not in use, the reception of the set traffic information station
is too poor because of external influences, it will automatically search for another
traffic information station.
A maximum of nine traffic announcements with a total length of up to four minutes
can be recorded. The oldest traffic report will always be overwritten if the memory
is full.
TIM recording times
You also have the possibility to set two TIM recording times, to which the unit will
also record traffic reports when the vehicle is not in use. Then the radio starts
according to the set TIM recording time with the recording of all the incoming traffic
reports on the set traffic information station.
For example, when you drive your vehicle to work everyday at a certain time, only
enter the approximate start time. The radio starts recording 90 minutes before the
set start time and stops recording 30 minutes after the set start time. In this way,
before you begin your journey, you can retrieve the last traffic reports and tune into
the current traffic situation of the distance to be driven.
Note
•
If a traffic announcement lasts more than four minutes, the start of the traffic
announcement will be overwritten.
•
If the vehicle has not been used for more than three days, no further traffic
announcements are recorded in order to stop the vehicle battery from running
down.
Playing traffic reports
– Press on the button , in order to listen to the stored traffic reports. The play
TIM
function starts with the last recorded traffic report and runs through to the
oldest recorded traffic report.
– Press the button , in order to switch to the beginning of the traffic announce-

ment you just listened to.
– Press the function key to skip a traffic announcement.

– You can interrupt the play function by pressing the button
changes to . Pressing the button

last point.

MEDIA operation

MEDIA main menu
Calling up the main menu MEDIA and changing the media source
– By pressing the button the play function of the last played audio source
MEDIA
will continue.
If audio sources are currently selectable at the unit, use the range selector key
to change between the audio sources played last.
MEDIA
If a previously played media source is selected again, play will continue from the last
played part.
If an audio source cannot be selected at the present time because, for example, no
data carrier has been inserted (e.g no memory card), the function key will be
displayed with a grey background.
Basic setting
. The button

will continue the play function from the

7