Kawai CL35 Owner's Manual page 35

1. Insert the Adjuster (G) approximately 1 cm
into the bottom of the Pedal Board (D).
Untie and extend the Pedal cable mounted
on the back of the Pedal Board.
2. Place the Side Panel (B) beside the Pedal
Board on the fl oor with its back sides facing
down.
Slide the pre-fi tted screws (a) and (b) into
the metal fi ttings on both sides of the Pedal
Board, and loosely fasten the single screw
(f).
3. Fasten the Back Panel (C) to the left and
right Side Panels using two long screws (c)
on either side.
Fasten the pre-fitted screws (a) and (b),
then tighten screw (f).
Raise the assembled Stand from the fl oor.
4. Carefully lift the Main Unit onto the top of the
assembled stand.
Place black Caps (J) over the two exposed
screws (c) on either side.
5. Align the holes on the bottom of the Main
Unit with the holes on the metal fi ttings of
the Side Panels.
Loosely fasten the Main Unit to the
assembled stand using two short screws (e)
on either side.
With the Main Unit and the assembled stand
correctly aligned, tighten the four screws
securely.
(bottom of the Pedal Board)
Front
Side Panel (B)
(a)
Pedal cable
Back
(b)
Screw (f)
ø4 x 16
Adjuster (G)
Screws (c)
M6 x 60
Side Panel (B)
Hole
Metal fi tting
Arrow
Adjuster hole
Pedal Board (D)
Back Panel (C)
Pedal Board (D)
Adjuster (G)
Main Unit (A)
Caps (J)
Stand
Hole
Metal fi tting
screws (e) M6 x 20
Page
35
6